Topic: Driver installation crashes in Windows 10
I've used CRT emudriver for more than 8 years now and I can't thank Calamity enough for these fabolous driver and his support in this forum
I use CRT emudrivers in Win XP (32-bit) and Windows 7 (64-bit).
I decided to migrate to genuine Windows 10. PC is the same where Windows 7 and emudrivers go together with no issues.
Windows 10, Fresh install, (2 times using different SSDs)
Run Setup.exe as admin (also tried standard run)
At first, everything is fine: setup displays
"emudriver needs to enable TESTSIGNING""
Click OK then I force reboot after been asked to.
OS is now in test mode (watermark at bottom right)
I run Setup once again and see popup prompts "Install drivers".
Click OK button.
Installation bar stops at 1/4 and after a couple of seconds, a BSOD appears
"Page fault in non paged area" - file atikmadg.sys
PC reboots then I can run Setup again and "Uninstall" option is active.
Apparently, driver is not properly installed:
display resolution goes 640x480 (via Quickres)
but when I switch to CRT display (changing analog cable from 4/3 LCD to CRT tv)
I have only a black screen.
Tried beta_15_12.6_W.7.8.10-64 and beta 14
Windows 10 Pro build 19041.vb_relase.191206-1406
Radeon 5700 series
no problem at all using Windows 7, same PC.
Could anyone suggest any further step, please?
Thank you in advance.